|
Post by ben on Jan 14, 2007 17:20:10 GMT -5
Hi guys... just bought a PAL-Radica....and already disassembled it.....
Now i search for a pin or a solder-bridge or something like that on the pcb......allowing me to switch from PAL to NTSC....
cause everybody knows PAL sucks....50Hz sucks........
I dont think PAL and NTSC radicas are different PCB's.....so there must be a pin to switch from PAL to NTSC.......
If anyone knows....let it know to me!!!
|
|
oompa loompa
I AM THE GOVERNATOR
"Git 'Er Dun!"
Posts: 1,301
|
Post by oompa loompa on Jan 30, 2007 23:41:49 GMT -5
I dunno of any jumper to switch between pal+ntsc yet
|
|
|
Post by ben on Feb 4, 2007 16:31:15 GMT -5
but where is the difference between PAL and NTSC???
I dont think they are manufactuaring....two different GOAC's...... that would cost to much money.....
I think there musst be some pins to connect or disconnect....but which???
|
|
oompa loompa
I AM THE GOVERNATOR
"Git 'Er Dun!"
Posts: 1,301
|
Post by oompa loompa on Feb 7, 2007 8:16:43 GMT -5
actually, i don't think an ntsc/pal switch exists
you don't need a jumper to switch between pal and ntsc video modes. the games themselves will switch between pal/ntsc in software. the jumper is only there to tell the software what type of system you have (whether japan/usa, or pal/ntsc clock)
i think the only difference between the pal and ntsc radicas are the games that are burned into the mask rom - as in the pal radica has the pal version of the games (no promises though!)
|
|